Even if your PopSocket is larger than normal, using only a . 5 in (1. 3 cm) layer of water will ensure that only the adhesive side touches the water when it is extended.
Be sure that your extended PopSocket rises above the surface and drain out water as necessary to avoid getting the rest of it wet. [1] X Research source
If you are concerned about ruining the adhesive, run the PopSocket under cold water for a few seconds instead, although soaking it is more effective. [3] X Research source
Do not let your PopSocket dry for more than 15 minutes at most or it may lose its ability to stick. If you accidentally leave it out, run it under cold water for a few seconds then let it dry again, although be aware that it may not regain its stickiness.
PopSockets usually come with some kind of design on the end of the grip, so even if you have to remove any additional stickers you’ve added, it will still have an aesthetic design. [6] X Research source
You can clean the adhesive separately, but if you get it wet before you’re ready to clean it, you could cause the adhesive to lose some of its stickiness. Wrap it or take care to not get it wet while cleaning the grip.
Scrub inside the grooves of the PopSocket’s expandable middle section with a cotton swab soaked in soapy water. Apply 70 percent rubbing alcohol to particularly stubborn stains or grime with a cotton swab, then rinse it under water again. Rubbing alcohol is great for removing stains as it evaporates quickly and leaves no damage.
You can also air dry the plastic grip. Expand the PopSocket then balance it on its side on a paper towel. This prevents the adhesive from sticking to the towel and will still allow the grip to air dry and drip dry.
